Home › Engine / Hybrid System › STOP AND START › ENGINE STOP AND START ECU › from 2016.03
RM3250E _51 Engine / Hybrid System _053992 STOP AND START _0264440 ENGINE STOP AND START ECU A

STOP AND START  ENGINE STOP AND START ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine stop and start ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Pre-crash safety system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Replacement of engine stop and start ECU
1.

Upload the number of starter operations

2.

Reset air conditioning information

3.

Learning of air conditioning information

4.

Clear the zero point calibration data

5.

Perform zero point calibration of the deceleration sensor

6.

Check electromagnetic oil pump



CAUTION:
B403904

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


PROCEDURE

Hide 1. READ NUMBER OF STARTER OPERATIONS

Hide 73900 2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 89261A 4.REMOVE ENGINE STOP AND START ECU

a.
A346056C01
0.042,0.042 0.26,0.208 0.219,0.167 10 true *A 0.063,2.615 0.271,2.781 0.208,0.167 10 true *B
*A for LHD
*B for RHD


Disconnect the 3 connectors and detach the clamp.


b.

Remove the 3 screws and engine stop and start ECU.