Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) › from 2016.03
RM3250E _58 Vehicle Interior _038070 SUPPLEMENTAL RESTRAINT SYSTEMS _0189247 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73920A 1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH (for Hi-back Seat Type)

a.

Install the front seat airbag assembly LH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

NOTICE:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.



B445456C02
0.073,0.042 0.438,0.292 0.365,0.25 12 false *A 3.938,0.052 4.26,0.281 0.323,0.229 12 false *B
*A for Type A *B for Type B



b.
B445454

Attach the wire harness clamp.

NOTICE:

Be careful not to damage the airbag wire harness.



Hide 73920A 2.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH (for Low-back Seat Type)

a.

Install the front seat airbag assembly LH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

NOTICE:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.



B445457C02
0.031,0.031 0.344,0.188 0.313,0.156 12 false *A 3.677,0.052 4.042,0.281 0.365,0.229 12 false *B
*A for Type A *B for Type B



b.
B445455

Attach the wire harness clamp.

NOTICE:

Be careful not to damage the airbag wire harness.



Hide 3.INSTALL SEATBACK COVER WITH PAD

Hide 71931 4.INSTALL FRONT SEAT HEADREST SUPPORT (for Low-back Seat Type)

Hide 71759C 5.INSTALL FRONT NO. 1 SEATBACK HOOK (w/ Seatback Hook)

Hide 6.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY LH

Hide 71862 7.INSTALL FRONT SEAT INNER CUSHION SHIELD LH

Hide 71812D 8.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 72495 9.INSTALL VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)

Hide 72526E 10.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION