Home › Vehicle Interior › SEAT › POWER SEAT SWITCH › from 2016.03
RM3250E _58 Vehicle Interior _038071 SEAT _0185774 POWER SEAT SWITCH A

SEAT  POWER SEAT SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be per formed after parts are removed, installed, or replaced during the power seat switch removal / installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 84921D 2.REMOVE POWER SEAT SWITCH KNOB LH (for Slide and Vertical, Lifter)

Hide 84921K 3.REMOVE POWER SEAT SWITCH KNOB LH (for Reclining)

Hide 71868A 4.REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH

Hide 71812D 5.REMOVE FRONT SEAT CUSHION SHIELD LH

Hide 84922C 6.REMOVE FRONT POWER SEAT SWITCH LH

a.
B415936

Remove the 3 screws and front power seat switch LH.