Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER › from 2016.03
RM3250E _58 Vehicle Interior _038071 SEAT _0185777 FRONT SEAT CUSHION HEATER A

SEAT  FRONT SEAT CUSHION HEATER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be per formed after parts are removed, installed, or replaced during the front seat cushion heater removal / installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY LH

Hide 71910A 2.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72526E 3.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

a.
B413187C01
0,0 0,0 false
V113147

Remove in this Direction
V100155

Protective Tape


With the reclining adjuster release handle LH pulled up.


b.

Using a thin-bladed screwdriver with its tip wrapped in protective tape, detach the claw and remove the reclining adjuster release handle LH while moving it in the removal direction shown in the illustration.

HINT:

Tape the thin-bladed screwdriver tip before use.



Hide 72495 4.REMOVE VERTICAL ADJUSTING HANDLE LH (for Manual Seat)

Hide 84921D 5.REMOVE POWER SEAT SWITCH KNOB LH (for Slide and Vertical, Lifter, for Power Seat)

Hide 84921K 6.REMOVE POWER SEAT SWITCH KNOB LH (for Reclining, for Power Seat)

Hide 71868A 7.REMOVE FRONT SEAT INNER NO. 1 CUSHION SHIELD LH (for Power Seat)

Hide 71812D 8.REMOVE FRONT SEAT CUSHION SHIELD LH

Hide 71862 9.REMOVE FRONT SEAT INNER CUSHION SHIELD LH

Hide 71014S 11.REMOVE FRONT SEATBACK FRAME SUB-ASSEMBLY LH

Hide 12.REMOVE SEAT CUSHION COVER WITH PAD

Hide 71071S 13.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

a.
B413218

Remove the 2 hog rings and disconnect the 2 straps of the separate type front seat cushion cover from the separate type front seat cushion pad.


b.
B403870

Remove the 18 hog rings and separate type front seat cushion cover.


c.
B403869

Remove the seat cover wire.