Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER(for Smart Cab) › from 2016.03
RM3250E _56 Audio / Visual / Telematics _038052 AUDIO / VIDEO _0182783 REAR DOOR SPEAKER(for Smart Cab) A

AUDIO / VIDEO  REAR DOOR SPEAKER(for Smart Cab)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door speaker removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

CAUTION:
B414214

w/ Airbag System:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 73178A 3.REMOVE SEAT BELT ANCHOR COVER CAP

Hide 73233 4.REMOVE OUTER LAP BELT ANCHOR COVER

Hide 73220 5.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67674A 7.REMOVE REAR DOOR FRAME GARNISH LH

Hide 86160B 8.REMOVE REAR SPEAKER ASSEMBLY

a.
E322687N01
2.26,2.354 2.417,2.552 0.156,0.198 10 false A

Disconnect the connector.


b.

Put a 5 mm (0.197 in.) drill bit into a drill.


c.

Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.

NOTICE:

Tape the drill bit to prevent the drill bit from going too deep.


Standard
Area Specified Condition
A 4 mm (0.157 in.)


d.

Lightly press the drill against the rivets, drill off the flanges of the 3 rivets and remove the rear speaker assembly.

CAUTION:

Be careful of the drilled rivet as it may become hot.


NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.




e.

Continue drilling and push out the remaining rivet fragments.


f.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.