Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › from 2016.03
RM3250E _56 Audio / Visual / Telematics _038052 AUDIO / VIDEO _0182784 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the radio antenna cord removal /installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

CAUTION:
B414214

w/ Airbag System:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55302A 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 86101 4.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)

a.

w/o Navigation System:

i.

Disconnect the connector.

E310295


ii.

Detach the clamps shown in the illustration.


iii.

Remove the bolt and antenna cord sub-assembly.



b.

w/ Navigation System:

i.

Disconnect the connector.

E310294


ii.

Detach the clamps shown in the illustration.


iii.

Remove the bolt and antenna cord sub-assembly.



Hide 86101 5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)

a.

w/o Navigation System:

i.

Disconnect the connector.

E322692


ii.

Detach the clamps shown in the illustration.


iii.

Remove the bolt and antenna cord sub-assembly.



b.

w/ Navigation System:

i.

Disconnect the connector.

E322693


ii.

Detach the clamps shown in the illustration.


iii.

Remove the bolt and antenna cord sub-assembly.



Hide 86101J 7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.
E322694

w/o Digital Audio Broadcasting Antenna

i.

Disconnect the connectors.


ii.

Detach the clamps and remove the No. 2 antenna cord sub-assembly.



b.
E322711

w/ Digital Audio Broadcasting Antenna

i.

Disconnect the connectors and remove the bolt.


ii.

Detach the clamps, guide and remove the No. 2 antenna cord sub-assembly.