Home › Power Source / Network › 2GD-FTV BATTERY / CHARGING › CHARGING SYSTEM › from 2016.03
RM3250E _57 Power Source / Network _038059 2GD-FTV BATTERY / CHARGING _0195912 CHARGING SYSTEM C

2GD-FTV BATTERY / CHARGING  CHARGING SYSTEM  P1602  Deterioration of Battery  


DESCRIPTION

The battery state sensor assembly detects the battery voltage. The battery condition is calculated from the voltage when the engine is running (except when cranking) and then output to the ECM. A DTC is output when battery degradation is determined based on this signal.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
P1602 Deterioration of Battery Diagnosis condition:
·

Engine running (except when cranking)


Malfunction status:
·

Battery capacity is abnormally low for 10 seconds or more.


Other:
·

1 trip


·

Battery

·

Wire harness or connector


Not displayed DTC stored

WIRING DIAGRAM

Refer to DTC P058A (Battery Monitor Module Performance).

Click herePower Source / Network>2GD-FTV BATTERY / CHARGING>CHARGING SYSTEM>P058A

CAUTION / NOTICE / HINT

NOTICE:
·

When P058A (Battery Monitor Module Performance) is output at the same time, perform the inspection for P058A (Battery Monitor Module Performance) first.

Click herePower Source / Network>2GD-FTV BATTERY / CHARGING>CHARGING SYSTEM>P058A

·

When P162B (Lost Communication with Battery Monitor Module) is output at the same time, perform the inspection for P162B (Lost Communication with Battery Monitor Module) first.

Click herePower Source / Network>2GD-FTV BATTERY / CHARGING>CHARGING SYSTEM>P162B

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.CHECK BATTERY STATE SENSOR ASSEMBLY INSTALLATION CONDITION
a.

Check the installation condition of the battery state sensor assembly.

Click herePower Source / Network>2GD-FTV BATTERY / CHARGING>BATTERY CURRENT SENSOR>INSTALLATION


Result:
Proceed to
OK
NG



OK

2.CHECK CHARGING SYSTEM

NG

INSTALL BATTERY STATE SENSOR ASSEMBLY CORRECTLY

2.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

3.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.
A331105C70
1.521,0.135 1.927,0.375 0.406,0.24 0.667,1.667 0.667,1.5 0.667,1.5 1.542,1.167 true 0.083,0.052 0.396,0.25 0.313,0.198 10 false *a 0.521,1.708 0.958,1.927 0.438,0.219 10 false AM21 1.604,0.177 2.063,0.375 0.458,0.198 10 false A63
*a Front view of wire harness connector
(to Battery Sstate Sensor Assembly)


Disconnect the A63 battery state sensor assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A63 (AM21) - Body ground Ignition switch ON 11 to 14 V



Result:
Result
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR