Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH › from 2016.03
RM3250E _54 Brake _038044 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0186162 VSC OFF SWITCH A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the skid control buzzer removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55410C 3.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55900 4.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

Hide 84013A 5.REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)

Hide 45287 6.REMOVE LOWER STEERING COLUMN COVER

Hide 55606 7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 73900 8.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 33504F 9.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58804A 10.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 55407C 11.REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY

Hide 84988L 12.REMOVE VSC OFF SWITCH

a.
C333986C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the VSC OFF switch connector.


b.

Detach the 2 claws and remove the VSC OFF switch from the lower instrument cover sub-assembly.