Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
44785
1.INSTALL BRAKE BOOSTER GASKET
Install a new brake booster gasket to the brake booster assembly.
44610
2.INSTALL BRAKE BOOSTER ASSEMBLY
Install the brake booster assembly with the 4 nuts.
for Diesel:
Install the 2 new grommets to the brake booster assembly.
w/ Entry and Start System:
Install the vacuum sensor assembly to the brake booster assembly.
Click hereEngine / Hybrid System>STOP AND START>VACUUM SENSOR ASSEMBLY>INSTALLATION
w/o Entry and Start System:
Install the vacuum warning switch assembly to the brake booster assembly.
Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM WARNING SWITCH(for Diesel)>INSTALLATION
Install the brake vacuum check valve assembly to the brake booster assembly.
for 1TR-FE, 2TR-FE:
Install the 2 new grommets to the brake booster assembly.
Install the 2 brake vacuum check valve assemblies to the brake booster assembly.
for 1GR-FE:
Install the grommet and brake vacuum check valve assembly to the brake booster assembly.
47201
3.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
4.CONNECT VACUUM HOSE
except 1TR-FE, 2TR-FE:
Connect the vacuum hose to the brake vacuum check valve assembly, and slide the clip to secure it.
for 1TR-FE:
Connect the 2 vacuum hoses to each brake vacuum check valve assembly, and slide the 2 clips to secure it.
47264D
5.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Install the brake master cylinder push rod clevis to the brake booster assembly.
47264A
6.INSTALL PUSH ROD PIN
47101A
7.INSTALL BRAKE PEDAL RETURN SPRING
8.BLEED BRAKE SYSTEM (w/ VSC)
9.BLEED BRAKE SYSTEM (w/o VSC)
10.BLEED CLUTCH LINE (for Manual Transmission)
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
11.CHECK AND ADJUST BRAKE PEDAL HEIGHT