The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning receiver removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE ROOF HEADLINING ASSEMBLY
89760C
4.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
Remove the bolt.
Detach the 2 guides to remove the tire pressure warning ECU and receiver.
Disconnect the connector from the tire pressure warning ECU and receiver.