Home › Engine / Hybrid System › 1TR-FE INTAKE / EXHAUST › INTAKE MANIFOLD › from 2016.08
RM3250E _51 Engine / Hybrid System _038001 1TR-FE INTAKE / EXHAUST _0181660 INTAKE MANIFOLD A

1TR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intake manifold removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative when not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 22030 1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 53882F 2.REMOVE FRONT FENDER SEAL LH

Hide 17111 4.REMOVE INTAKE MANIFOLD

a.
A345950

Detach the 4 wire harness clamps from the 2 wire harness clamp brackets.


b.
A346137

Detach the No. 1 fuel hose from the intake manifold.


c.
A345951

for RHD:

Detach the engine wire harness clamp.


d.
A356122C02
0.01,0.177 0.323,0.333 0.313,0.156 10 true *A 0.01,2.479 0.375,2.646 0.365,0.167 10 true *B
*A for LHD
*B for RHD


Remove the bolt and disconnect the heater water pipe sub-assembly from the intake manifold.


e.
A345952

Detach the No. 2 water by-pass hose from the intake manifold.


f.

Slide the clip and disconnect the No. 3 PCV hose from the intake manifold.


g.
A345956

Slide the clip and disconnect the union to connector tube hose from the intake manifold.


h.

Detach the clamp, and then slide the clip and remove the purge line hose from the intake manifold.


i.
A345957

w/ Intake Manifold Insulator:

Remove the 2 No. 2 intake manifold insulators from the intake manifold.


j.
A252479

Remove the 5 bolts, 2 nuts and intake manifold.


k.

Remove the gasket from the intake manifold.


l.
A351047

for LHD:

Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.


m.
A345958

for RHD:

Remove the 3 bolts and 3 wire harness clamp brackets from the intake manifold.


n.

w/ Intake Manifold Insulator:

Remove the intake manifold insulator from the intake manifold.