Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR(for 2WD)
RM33J0E _53 Suspension _038474 FRONT SUSPENSION _0187666 FRONT STABILIZER BAR(for 2WD) A

FRONT SUSPENSION  FRONT STABILIZER BAR(for 2WD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front stabilizer bar removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Front wheel alignment adjustment
·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


·

DTCs are output

·

ABS warning light illumination

·

Slip indicator light illumination

·

VSC disable or malfunctioning


(Click here)


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 51405D 2.REMOVE ENGINE UNDER BRACE SUB-ASSEMBLY

Hide 48810 3.REMOVE FRONT STABILIZER LINK ASSEMBLY LH

a.
C322851

Remove the 2 nuts, 2 retainers, 2 cushions and front stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.



Hide 48820B 4.REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 48824 5.REMOVE FRONT STABILIZER BRACKET

a.
C322852

Remove the 4 bolts and 2 front stabilizer brackets.


Hide 48815 6.REMOVE FRONT NO. 1 STABILIZER BAR BUSH

a.

Remove the 2 front No. 1 stabilizer bar bushes.


Hide 48811 7.REMOVE FRONT STABILIZER BAR

a.

Remove the front stabilizer bar from the vehicle body.