Home › Suspension › REAR SUSPENSION › REAR LEAF SPRING(for 4WD and Pre-Runner) › 2015.06–2015.11
RM33J0E _53 Suspension _038475 REAR SUSPENSION _0187672 REAR LEAF SPRING(for 4WD and Pre-Runner) A

REAR SUSPENSION  REAR LEAF SPRING(for 4WD and Pre-Runner)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48220 1.INSTALL REAR LEAF SPRING ASSEMBLY LH

a.

Install the rear leaf spring assembly LH to the vehicle body.


Hide 48210A 2.INSTALL REAR UPPER SPRING SHACKLE BUSH

a.

Install 2 new rear upper spring shackle bushes to the vehicle frame.


Hide 3.INSTALL NO. 2 REAR SPRING SHACKLE SUB-ASSEMBLY

a.

Install the No. 2 rear spring shackle sub-assembly to the rear leaf spring assembly LH and vehicle frame.


Hide 4.TEMPORARILY INSTALL SPRING SHACKLE INNER PLATE

a.
C334407C01
2.354,3.01 2.667,3.208 0.313,0.198 10 false *a
*a Bottom of Vehicle


Temporarily install the spring shackle inner plate to the No. 2 rear spring shackle sub-assembly with the 2 washers and 2 nuts shown in the illustration.

HINT:

After stabilizing the suspension, tighten the nuts.



Hide 5.TEMPORARILY INSTALL REAR LEAF SPRING PIN BOLT

a.

Temporarily install the rear leaf spring pin bolt with the washer and nut.

HINT:
·

The pin bolt can be installed from either side of the spring.

·

After stabilizing the suspension, tighten the nut.




Hide 48046A 6.TEMPORARILY INSTALL REAR SPRING U BOLT

a.

Temporarily install the spring U bolt seat sub-assembly and rear spring bumper with the 2 rear spring U bolts, 4 washers and 4 nuts.

HINT:

When tightening the U bolts, tighten the nuts in diagonal pairs.



Hide 48540 7.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

Hide 46430 8.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Connect the No. 3 parking brake cable assembly with the bolt.

Torque:
14 N*m (143 kgf*cm, 10 ft.*lbf)


Hide 10.TIGHTEN SPRING SHACKLE INNER PLATE

a.

Tighten the spring shackle inner plate with the 2 nuts.

Torque:
60 N*m (612 kgf*cm, 44 ft.*lbf)


Hide 11.TIGHTEN REAR SPRING PIN BOLT

a.

Tighten the rear spring pin nut.

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)


Hide 48047 12.TIGHTEN SPRING U BOLT SEAT SUB-ASSEMBLY LH

a.

Tighten the set nut.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


Hide 13.INSTALL REAR WHEEL