Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
46430
2.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and disconnect the No. 3 parking brake cable assembly from the rear leaf spring assembly LH.
48540
3.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH
48046A
4.REMOVE REAR SPRING U BOLT
Remove the 4 nuts, 4 washers, 2 rear spring U bolts, rear spring bumper and spring U bolt seat sub-assembly.
5.REMOVE REAR LEAF SPRING PIN BOLT
Remove the nut, washer and rear leaf spring pin bolt.
6.REMOVE SPRING SHACKLE INNER PLATE
Remove the 2 nuts, 2 washers and spring shackle inner plate.
7.REMOVE NO. 2 REAR SPRING SHACKLE SUB-ASSEMBLY
Using a screwdriver, remove the No. 2 rear spring shackle sub-assembly.
Tape the screwdriver tip before use.
48210A
8.REMOVE REAR UPPER SPRING SHACKLE BUSH
Using a screwdriver, remove the 2 rear upper spring shackle bushes from the vehicle frame.
Tape the screwdriver tip before use.
48220
9.REMOVE REAR LEAF SPRING ASSEMBLY LH
Remove the rear leaf spring assembly LH from the vehicle body.