Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.DISCONNECT FRONT FLEXIBLE HOSE
47750
3.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
47722
4.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH
43512
5.REMOVE FRONT DISC
6.INSPECT FRONT AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the front axle hub.
0.05 mm (0.00197 in.)
Make sure that the dial indicator is set perpendicular to the measurement surface.
If the looseness is more than the maximum, replace the front axle hub sub-assembly.
7.INSPECT FRONT AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the front axle hub inside the front axle hub bolt.
0.05 mm (0.00197 in.)
Make sure that the dial indicator is set perpendicular to the measurement surface.
If the runout is more than the maximum, replace the front axle hub sub-assembly.
43512
8.INSTALL FRONT DISC
47722
9.INSTALL FRONT DISC BRAKE CYLINDER MOUNTING LH
47750
10.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH
11.CONNECT FRONT FLEXIBLE HOSE
12.INSTALL FRONT WHEEL