This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock actuator or upper bracket assembly stops for 10 seconds or more.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2786 | No Response from Steering Lock ECU | Communication between the certification ECU (smart key ECU assembly) and steering lock actuator or upper bracket assembly stops for 10 seconds or more. | ·
Steering lock actuator or upper bracket assembly ·
Certification ECU (smart key ECU assembly) ·
Harness or connector |
When using the GTS with the ignition switch off to troubleshoot:
Connect the GTS to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the GTS and vehicle begins.
Inspect the fuses for circuits related to this system before performing the following procedure.
If the certification ECU (smart key ECU assembly) or steering lock actuator or upper bracket assembly is replaced, refer to the Service Bulletin.
When the communication between the steering lock actuator or upper bracket assembly and certification ECU (smart key ECU assembly) stops, DTC B2785 is also stored.
Clear the DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC B2786 is output |
| DTC B2786 is not output |
DTC B2786 is output
DTC B2786 is not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the G69 certification ECU (smart key ECU assembly) connector.
Disconnect the G71 steering lock actuator or upper bracket assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G69-5 (LIN) - G71-5 (LIN) | Always | Below 1 Ω |
| G69-5 (LIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Steering Lock Actuator or Upper Bracket Assembly) |
Disconnect the steering lock actuator or upper bracket assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G71-1 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G71-7 (B) - Body ground | Always | 11 to 14 V |
| G71-6 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the steering lock actuator or upper bracket assembly with a new one.
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>DISASSEMBLY
Clear the DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC B2786 is not output |
| DTC B2786 is output |
DTC B2786 is not output
DTC B2786 is output