Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
45100
1.REMOVE STEERING WHEEL ASSEMBLY
55410C
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55900
3.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
|
Protective Tape |
Put protective tape around the air conditioning control assembly.
Detach the clip and remove the air conditioning control assembly.
Disconnect the connector.
Disconnect the cooler thermistor (room temperature sensor) connector.
Disconnect the air conditioning duct sub-assembly.
84223A
4.REMOVE TRANSFER POSITION SWITCH (for 4WD)