The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the steering wheel removal/installation are shown below.
Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing.
for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION
for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45130
3.REMOVE STEERING WHEEL PAD ASSEMBLY
45116
4.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Remove the 2 screws.
Detach the 6 guide pins and 2 claws to remove the No. 1 steering wheel ornament.
84250A
5.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
84632
6.REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
45100
7.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel set nut.
| *a | Matchmark |
| *b | Hold |
| *c | Turn |
Put matchmarks on the steering wheel and steering main shaft.
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.
45184
8.REMOVE LOWER STEERING WHEEL BOSS COVER
Detach the guide pins and claws to remove the lower steering wheel boss cover.