1.ADJUST COMPRESSOR OIL
When replacing the compressor assembly with magnet clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor assembly with magnet clutch before installation.
(Oil capacity inside the new compressor assembly with magnet clutch: 100 to 115 cc (3.38 to 3.89 fl.oz)) - (Remaining oil amount in the removed compressor assembly with magnet clutch) = (Oil amount to be removed from the new compressor)
If a new compressor assembly with magnet clutch is installed without removing some oil, there will be too much oil in the system due to the oil remaining in the pipes of the vehicle. Excessive oil in the system prevents heat exchange in the refrigeration cycle and causes ineffective cooling.
If the amount of oil remaining in the old compressor assembly with magnet clutch is too small, check the air conditioning system for oil leaks.
Be sure to use ND-OIL 8 or equivalent compressor oil. If any compressor oil other than ND-OIL 8 is used, compressor assembly with magnet clutch insulation performance may decrease, resulting in a leak of electric power.
2.INSTALL COMPRESSOR ASSEMBLY WITH MAGNET CLUTCH
Tighten the 4 bolts in the order shown in the illustration to install the compressor assembly with magnet clutch.
Connect the connector.
Attach the clamp.
88704
3.CONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the vinyl tape from the suction hose sub-assembly and compressor assembly with magnet clutch.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor assembly with magnet clutch.
ND-OIL 8 or equivalent
Install the O-ring to the suction hose sub-assembly.
Keep the O-ring and O-ring fitting surfaces free of foreign matter.
Connect the suction hose sub-assembly to the compressor assembly with magnet clutch with the bolt.
88711
4.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the vinyl tape from the No. 1 cooler refrigerant discharge hose and compressor assembly with magnet clutch.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the compressor assembly with magnet clutch.
ND-OIL 8 or equivalent
Install the O-ring to the No. 1 cooler refrigerant discharge hose.
Keep the O-ring and O-ring fitting surfaces free of foreign matter.
Connect the No. 1 cooler refrigerant discharge hose to the compressor assembly with magnet clutch with the bolt.
16361A
5.INSTALL FAN AND GENERATOR V BELT
for 1KD-FTV:
Click hereEngine / Hybrid System>1KD-FTV ENGINE MECHANICAL>DRIVE BELT>INSTALLATION
for 2KD-FTV:
Click hereEngine / Hybrid System>2KD-FTV ENGINE MECHANICAL>DRIVE BELT>INSTALLATION
12601E
6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)
7. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
8.WARM UP ENGINE
9.INSPECT FOR REFRIGERANT LEAK