Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM33J0E _54 Brake _038477 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0192390 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1268  Transfer L4 Position Switch Circuit  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C1268 Transfer L4 Position Switch Circuit The skid control ECU receives an L4 abnormal status signal from the 4 wheel drive control ECU via CAN.
·

Touch select 2-4 and high-low system

·

Skid control ECU (Brake actuator assembly)


-

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform Test Mode (Signal Check) to acquire the rear differential lock identification information.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE


HINT:

When DTC U0114 is output together with DTC C1268, inspect and repair the trouble areas indicated by DTC U0114 first.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>U0073


PROCEDURE

1.INSPECT TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
a.

Turn the 4WD control switch (transfer position switch) to L4, and then drive the vehicle and check that there are no problems with the touch select 2-4 and high-low system.

OK:

There are no problems with the touch select 2-4 and high-low system.


Result:
Result
OK
NG




OK

2.RECONFIRM DTC

NG

2.RECONFIRM DTC
a.

Clear the DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105

b.

Turn the ignition switch off.


c.

Start the engine.


d.

Turn the 4WD control switch (transfer position switch) to H2 or H4.


e.

Turn the 4WD control switch (transfer position switch) to L4, drive the vehicle, and then check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Proceed to
DTC is not output
DTC is output




DTC is not output

DTC is output