Home › Engine / Hybrid System › 2TR-FE COOLING › THERMOSTAT
RM33J0E _51 Engine / Hybrid System _038459 2TR-FE COOLING _0193176 THERMOSTAT A

2TR-FE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.
A340090C01
2.167,0.865 2.167,0.771 2.167,0.771 2.271,0.771 false 2.823,0.865 2.823,0.771 2.823,0.771 2.927,0.771 false 1.781,1.917 1.948,1.917 1.948,1.917 2.375,1.594 true 2.083,0.875 2.292,1.063 0.208,0.188 10 false *1 2.302,0.385 2.49,0.573 0.188,0.188 10 false *a 2.969,0.385 3.198,0.573 0.229,0.188 10 false *b 2.313,1.094 2.5,1.25 0.188,0.156 10 true *c 1.583,1.833 1.792,2 0.208,0.167 10 true *d 2.531,1.177 2.771,1.344 0.24,0.167 10 true 10° 2.083,1.188 2.313,1.344 0.229,0.156 10 true 10° 2.74,0.875 2.979,1.042 0.24,0.167 10 false *1
*1 Gasket
*a CORRECT
*b INCORRECT
*c Upward
*d Jiggle Valve


Install a new gasket to the thermostat.

HINT:

When installing the thermostat to the gasket, be careful not to deform the gasket. Make sure that the thermostat is properly installed into the groove of the gasket as shown in the illustration.



b.

Insert the thermostat into the timing chain cover sub-assembly with the jiggle valve facing straight upward.

HINT:

The jiggle valve may be set within 10° of either side of the prescribed position.



Hide 16321 2.INSTALL WATER INLET

a.

Install a new gasket and the water inlet with the 2 nuts and bolt.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


b.

Connect the power steering oil pressure switch connector.


Hide 16572 3.CONNECT RADIATOR HOSE OUTLET

a.

Connect the radiator hose outlet to the water inlet, and slide the hose clamp to secure the hose.


Hide 51410 6.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)