Do not remove the radiator cap sub-assembly, cylinder block drain cock plugs or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
53293C
1.REMOVE RADIATOR SIDE DEFLECTOR
51410
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)
3.DRAIN ENGINE COOLANT
16593
4.REMOVE NO. 1 RADIATOR AIR GUIDE
Remove the 4 clips and No. 1 radiator air guide.
Do not reuse the clip.
16571
5.REMOVE RADIATOR HOSE INLET
w/ Secondary Air Injection System:
Disconnect the hose clamp from the radiator hose inlet and cylinder head.
Slide the 2 hose clamps and remove the radiator hose inlet from the radiator assembly and cylinder head.
16572
6.REMOVE RADIATOR HOSE OUTLET
| *a | Push |
Detach the clamp from the radiator hose outlet.
Slide the 2 hose clamps and remove the radiator hose outlet from the radiator assembly and water inlet.
17621A
7.DISCONNECT AIR PUMP INLET (w/ Secondary Air Injection System)
16470
8.REMOVE RADIATOR RESERVOIR
Disconnect the reservoir hose from the radiator assembly.
Remove the 2 bolts, radiator reservoir and grommet.
16711
9.REMOVE FAN SHROUD
Detach the 6 clamps and disconnect the wire harness from the radiator assembly and fan shroud.
Loosen the 4 nuts holding the fluid coupling fan.
Remove the fan and generator V belt.
Click hereEngine / Hybrid System>2TR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL
Detach the 2 claws holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the fan shroud together with the fluid coupling fan.
Be careful not to damage the radiator core.
Remove the fan pulley from the engine water pump assembly.
Remove the clamp from the fan shroud.
16400
10.REMOVE RADIATOR ASSEMBLY
Remove the 4 bolts.
w/ Air Conditioning System:
Slide the radiator assembly with cooler condenser to the engine side.
w/o Air Conditioning System:
Slide the radiator assembly to the engine side.
w/ Air Conditioning System:
Detach the 2 claws and 2 guides to disconnect the cooler condenser assembly from radiator assembly.
Do not allow the radiator assembly to interfere with other parts.
Do not apply any excessive force to the cooler condenser assembly and cooler pipe.
Remove the radiator assembly from the vehicle.
w/ Air Conditioning System:
Do not apply excessive force to the cooler condenser assembly or pipe when removing the radiator assembly.
16546
11.REMOVE RADIATOR PROTECTOR (w/o Air Conditioning System)
Detach the 2 claws and 2 guides to remove the radiator protector.
16407A
12.REMOVE RADIATOR DRAIN COCK PLUG
Remove the radiator drain cock plug from the radiator assembly.
Remove the O-ring from the radiator drain cock plug.