To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hands and clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not remove the engine oil pressure switch assembly while the engine is hot.
1.INSPECT ENGINE OIL QUALITY
Check the engine oil for deterioration, water contamination, discoloration or thinning.
If the quality is visibly poor, replace the engine oil and oil filter sub-assembly.
Click hereEngine / Hybrid System>2TR-FE LUBRICATION>OIL AND OIL FILTER>REPLACEMENT
2.CHECK ENGINE OIL LEVEL
Warm up the engine, and then stop the engine and wait 5 minutes.
Check that the engine oil level is between the engine oil level dipstick low level mark and full level mark.
If the oil level is low, check for leakage and add engine oil up to the full level mark.
Do not fill engine oil above the full level mark.
3.INSPECT OIL PRESSURE
To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hands and clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not remove the engine oil pressure switch assembly while the engine is hot.
| *a | Oil Pressure Gauge |
| *b | Adapter |
Remove the engine oil pressure switch assembly.
Click hereEngine / Hybrid System>2TR-FE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL
Install an oil pressure gauge with the adapter.
Warm up the engine.
Measure the engine oil pressure, and check that it is within the standard range.
| Condition | Specified Condition |
|---|---|
| Idle | 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher |
| 3000 rpm | 160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi) |
If the result is not as specified, check the quality of the engine oil and check the oil paths for clogging. Repair or replace if necessary. If the engine oil pressure is still not as specified, check the timing chain cover sub-assembly.
Click hereEngine / Hybrid System>2TR-FE LUBRICATION>OIL PUMP>INSPECTION
Remove the oil pressure gauge and adapter.
Install the engine oil pressure switch assembly.
Click hereEngine / Hybrid System>2TR-FE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION