Home › Engine / Hybrid System › 2TR-FE LUBRICATION › OIL PRESSURE SWITCH
RM33J0E _51 Engine / Hybrid System _038460 2TR-FE LUBRICATION _0193180 OIL PRESSURE SWITCH A

2TR-FE LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Remove any oil from the threads of the engine oil pressure switch assembly.


b.

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.



c.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:
14.7 N*m (150 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



d.

Connect the engine oil pressure switch assembly connector.


Hide 51442 4.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 51410 5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)