Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM33J0E _51 Engine / Hybrid System _038454 2TR-FE ENGINE CONTROL _0193671 AIR FUEL RATIO SENSOR A

2TR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.
A345941C01
0.833,3 1,3 1,3 1.344,0.938 true 2.74,0.906 3,1.115 0.26,0.208 10 true *a 0.542,2.917 1,3.115 0.458,0.198 10 false SST
*a Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00011  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click here

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 39.4 N*m (402 kgf*cm, 29 ft.*lbf)




b.

Attach the 3 wire harness clamps to the vehicle body.


c.

Connect the air fuel ratio sensor connector.