Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM33J0E _51 Engine / Hybrid System _038454 2TR-FE ENGINE CONTROL _0193671 AIR FUEL RATIO SENSOR A

2TR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leaks from exhaust system


Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
·
A343693

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 53882K 1.REMOVE FRONT FENDER SEAL RH

Hide 89467B 2.REMOVE AIR FUEL RATIO SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A345939

Disconnect the air fuel ratio sensor connector.


b.

Detach the 3 wire harness clamps.


c.
A345940N01
2.167,1.833 2,1.833 2,1.833 1.823,0.781 true 2.188,1.74 2.51,1.938 0.323,0.198 10 true SST

Using SST, remove the air fuel ratio sensor.

SST
09224-00011