Home › Engine / Hybrid System › 2GD-FTV STARTING › STARTER(for 2.2 kW Type)
RM33J0E _51 Engine / Hybrid System _038444 2GD-FTV STARTING _0193859 STARTER(for 2.2 kW Type) A

2GD-FTV STARTING  STARTER(for 2.2 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Temporarily install the starter assembly and ground cable with the 2 bolts.


b.

Install the clutch release cylinder assembly with the 2 bolts.

Torque:
11.8 N*m (120 kgf*cm, 9 ft.*lbf)


c.

Tighten the 2 bolts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


d.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


e.

Connect the starter connector.


f.

Install the starter terminal cap.


Hide 53882K 2.INSTALL FRONT FENDER SEAL LH

a.

Install the front fender seal LH with 6 new clips.


Hide 51442 3.INSTALL NO. 2 ENGINE UNDER COVER

Hide 51410 4.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION