Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1KD-FTV, 2KD-FTV)
RM33J0E _55 Steering _038482 POWER ASSIST SYSTEMS _0193963 VANE PUMP(for 1KD-FTV, 2KD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1KD-FTV, 2KD-FTV)  INSTALLATION  


PROCEDURE

Hide 44320 1.INSTALL VANE PUMP ASSEMBLY

a.
C330516C01
0,0 0,0 false
V100135

MP Grease
V113147

Install in this Direction


Coat a new O-ring with MP grease and install it to the vane pump assembly.


b.

Install the vane pump assembly with the 2 nuts.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.
C330517C01
1.052,0.365 1.24,0.531 0.188,0.167 10 true *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the tube to the vane pump assembly.

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 255 mm (10.039 in.)): 40.5 N*m (413 kgf*cm, 30 ft.*lbf)




Hide 44348A 3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Connect the oil reservoir to pump hose with slide the clip.

HINT:
·

Connect the pump side of the oil reservoir to pump hose so that the paint mark faces the front of the vehicle.

·

Make sure the claw of the clamp on the vane pump assembly side faces the front of the vehicle.




Hide 4.ADD POWER STEERING FLUID

Hide 6.CHECK FOR POWER STEERING FLUID LEAK

Hide 53737B 7.INSTALL FRONT FENDER APRON SEAL LH

a.

Attach the new 6 clips to install the front fender apron seal LH.


Hide 51410 8.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

Hide 51442 9.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 10.INSTALL FRONT WHEEL LH