Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM33J0E _51 Engine / Hybrid System _038437 2GD-FTV ENGINE CONTROL _0195885 CRANKSHAFT POSITION SENSOR A

2GD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the crankshaft position sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


(Click here)
w/ DPF:(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.
Replacement of engine assembly
·

Input Injector Compensation Code

·

Pilot Quantity Learning


Engine starting (Click here)
w/ DPF:(Click here)
Clear Crank Time Compensation Data Engine starting (Click here)
w/ DPF:(Click here)
for 4WD:

Front wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)

PROCEDURE

Hide 31210 2.REMOVE CLUTCH COVER ASSEMBLY

Hide 31250 3.REMOVE CLUTCH DISC ASSEMBLY

Hide 13405 4.REMOVE FLYWHEEL SUB-ASSEMBLY

Hide 12581A 6.REMOVE NO. 1 CYLINDER BLOCK INSULATOR

Hide 12585 7.REMOVE NO. 5 CYLINDER BLOCK INSULATOR

Hide 27148C 8.REMOVE CONNECTING WIRE

a.
A346045

Disconnect the 2 connectors and clamp and remove the connecting wire.


Hide 9.REMOVE CRANKSHAFT POSITION SENSOR HARNESS BRACKET

a.
A346046

Remove the bolt and crankshaft position sensor harness bracket from the cylinder block sub-assembly.


Hide 11401Q 10.REMOVE CRANKSHAFT POSITION SENSOR

a.
A346047

Remove the bolt and crankshaft position sensor from the rear oil seal retainer.