Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › AIR FUEL RATIO SENSOR
RM33J0E _51 Engine / Hybrid System _038437 2GD-FTV ENGINE CONTROL _0195889 AIR FUEL RATIO SENSOR A

2GD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of air fuel ratio sensor Clear A/F Sensor Compensation data - (Click here)
w/ DPF:(Click here)

CAUTION:
·
A343693

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 53882F 1.REMOVE FRONT FENDER SEAL RH

a.

Remove the 6 clips and front fender seal RH.


Hide 89467B 2.REMOVE AIR FUEL RATIO SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A349884N01
0.688,0.51 0.781,0.51 0.781,0.51 1.021,1.094 true 0.385,0.427 0.688,0.594 0.302,0.167 10 true SST

Disconnect the connector and clamp.


b.

Using SST, remove the air fuel ratio sensor.

SST
09224-00011