Home › Engine / Hybrid System › 2GD-FTV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM33J0E _51 Engine / Hybrid System _038438 2GD-FTV ENGINE MECHANICAL _0196034 REAR CRANKSHAFT OIL SEAL A

2GD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear crankshaft oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write


Engine starting
·

w/ DPF:

(Click here)

·

w/o DPF:

(Click here)


Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.
Replacement of engine assembly
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting
·

w/ DPF:

(Click here)

·

w/o DPF:

(Click here)


Clear Crank Time Compensation Data Engine starting
·

w/ DPF:

(Click here)

·

w/o DPF:

(Click here)


for 4WD:

Front wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)

PROCEDURE

Hide 31210 2.REMOVE CLUTCH COVER ASSEMBLY

Hide 31250 3.REMOVE CLUTCH DISC ASSEMBLY

Hide 13405 4.REMOVE FLYWHEEL SUB-ASSEMBLY

Hide 11381A 6.REMOVE REAR ENGINE OIL SEAL

a.
A340242C01
1.885,1.344 1.885,1.594 false 1.833,0.969 2.333,0.5 2.333,0.5 2.5,0.5 true 2.521,0.375 2.75,0.563 0.229,0.188 10 true *a 1.844,1.625 2.156,1.781 0.313,0.156 10 false *b 1.156,1.635 1.469,1.792 0.313,0.156 10 false *c
*a Protective Tape
*b Cloth
*c Cut


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a cloth and screwdriver, pry out the rear engine oil seal from the rear engine oil seal retainer.

NOTICE:

Be careful not to damage the crankshaft and rear engine oil seal retainer.


HINT:
·

After removal, check the crankshaft for damage. If damaged, smooth the surface with #400 sandpaper.

·

Tape the screwdriver tip before use.