This DTC is output when a short to ground in the transfer shift motor and A.D.D. shift motor* drive circuit is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P17A9 | Transfer Shift Motor Control Circuit Low | ·
Diagnosis Condition: Directly after the ignition switch is turned to ON, or while the ignition switch is turned to ON (transfer shift motor not operating) ·
Malfunction Status: Short to ground in the transfer shift motor and A.D.D. shift motor* drive circuits ·
Malfunction Time: 0.5 seconds or more (after the ignition switch is turned to ON, 0.05 seconds or more) ·
Other: 1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Transfer shift actuator assembly ·
A.D.D. actuator (differential motor actuator assembly)* |
*: w/ A.D.D. Actuator
Disconnect the C40 4 wheel drive control ECU connector.
| *A | w/ A.D.D. Actuator |
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C40-8 (TM1) or C40-7 (TM2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C40-2 (DM1) or C40-6 (DM2) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (transfer shift actuator assembly side) | B |
| NG (A.D.D. actuator (differential motor actuator assembly) side) (w/ A.D.D. Actuator) | C |
A
B
C
Disconnect the C40 4 wheel drive control ECU connector.
Disconnect the C41 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C40-8 (TM1) or C41-2 (TM1) - Body ground | Always | 10 kΩ or higher |
| C40-7 (TM2) or C41-1 (TM2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the C40 4 wheel drive control ECU connector.
Disconnect the C7 A.D.D. actuator (differential motor actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C40-2 (DM1) or C7-1 (DM1) - Body ground | Always | 10 kΩ or higher |
| C40-6 (DM2) or C7-2 (DM2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG