1.REMOVE MANUAL TRANSMISSION ASSEMBLY
31126
2.REMOVE CLUTCH RELEASE FORK BOOT
31230
3.REMOVE CLUTCH RELEASE BEARING ASSEMBLY
31236B
4.REMOVE RELEASE FORK SUPPORT
31111
5.REMOVE CLUTCH HOUSING
33131D
6.REMOVE FRONT BEARING RETAINER
33124C
7.REMOVE NO. 1 OIL RECEIVER PIPE
Remove the No. 1 oil receiver pipe from the front bearing retainer.
33131A
8.REMOVE FRONT TRANSMISSION BEARING RETAINER OIL SEAL
| *a | Protective Tape |
Using a screwdriver, pry out the front transmission bearing retainer oil seal.
Do not damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.
Tape the screwdriver tip before use.
33131A
9.INSTALL FRONT TRANSMISSION BEARING RETAINER OIL SEAL
Using SST and a press, press in a new front transmission bearing retainer oil seal.
0.8 to 1.8 mm (0.0315 to 0.0708 in.)
33124C
10.INSTALL NO. 1 OIL RECEIVER PIPE
Install the No. 1 oil receiver pipe to the front bearing retainer.
33131D
11.INSTALL FRONT BEARING RETAINER
31111
12.INSTALL CLUTCH HOUSING
31236B
13.INSTALL RELEASE FORK SUPPORT
31230
14.INSTALL CLUTCH RELEASE BEARING ASSEMBLY
31126
15.INSTALL CLUTCH RELEASE FORK BOOT
16.INSTALL MANUAL TRANSMISSION ASSEMBLY