When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing chain case assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.
Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve or fuel pressure sensor, etc.
Make sure foreign matter does not enter the fuel path.
23810A
1.INSTALL COMMON RAIL ASSEMBLY
Install the common rail assembly with the 2 nuts.
Connect the fuel pressure sensor connector to the common rail assembly.
Attach the wire harness clamp.
23282D
2.INSTALL NO. 4 FUEL HOSE
Connect the No. 4 fuel hose to the common rail assembly, and slide the clamp to secure it.
3.TEMPORARILY INSTALL NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY
4.TIGHTEN NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY
23804C
5.INSTALL FUEL INLET PIPE SUB-ASSEMBLY
23804D
6.INSTALL NO. 4 FUEL PIPE SUB-ASSEMBLY (w/ DPF)
7.INSTALL WIRING HARNESS CLAMP BRACKET
25800
8.INSTALL EGR COOLER SUB-ASSEMBLY AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
10.BLEED AIR FROM FUEL SYSTEM
11.INSPECT FOR FUEL LEAK