Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DECELERATION SENSOR(for 4WD and Pre-Runner without VSC)
RM33J0E _54 Brake _038477 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0199130 DECELERATION SENSOR(for 4WD and Pre-Runner without VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DECELERATION SENSOR(for 4WD and Pre-Runner without VSC)  INSTALLATION  


PROCEDURE

Hide 89441A 1.INSTALL DECELERATION SENSOR

a.

Install the deceleration sensor with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:
·

Do not use any parts which have been dropped or struck.

·

After installation, check that nothing is caught between the deceleration sensor and body, causing it to tilt.

·

Do not do anything to deform the bracket of the sensor, such as kicking or stepping on it.




b.

Connect the deceleration sensor connector.

NOTICE:

Securely connect the deceleration sensor connector.



c.

Attach the fuel lid control cable clamp to the deceleration sensor.


Hide 46334 2.INSTALL INTERMEDIATE LEVER PROTECTOR

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION