Home › Engine / Hybrid System › 2GD-FTV EMISSION CONTROL › EGR COOLER
RM33J0E _51 Engine / Hybrid System _038440 2GD-FTV EMISSION CONTROL _0201057 EGR COOLER A

2GD-FTV EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the EGR cooler removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of diesel throttle body assembly Perform initialization -
·

w/ DPF:

(Click here)

·

w/o DPF:

(Click here)


Replacement of electric EGR control valve assembly Perform initialization -
·

w/ DPF:

(Click here)

·

w/o DPF:

(Click here)



CAUTION:
A343692

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


PROCEDURE

Hide 26100G 2.REMOVE DIESEL THROTTLE BODY ASSEMBLY

Hide 16278 3.REMOVE NO. 2 WATER BY-PASS PIPE

Hide 89421C 5.REMOVE TURBO PRESSURE SENSOR

Hide 44763C 6.REMOVE NO. 2 HOSE TO HOSE TUBE

Hide 12632 7.REMOVE NO. 2 ENGINE COVER BRACKET

Hide 23300 8.DISCONNECT FUEL FILTER ASSEMBLY

Hide 25625 10.REMOVE EGR VALVE BRACKET

Hide 16206B 12.DISCONNECT NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A343898

Disconnect the No. 4 fuel hose from the No. 3 water by-pass pipe sub-assembly.


b.
A345813

Slide the clamp and disconnect the No. 8 water by-pass hose from the No. 3 water by-pass pipe sub-assembly.


c.

Slide the clamp and disconnect the No. 9 water by-pass hose from the electric EGR control valve assembly.


d.

Remove the 2 bolts and No. 3 water by-pass pipe sub-assembly from the No. 1 EGR cooler.


Hide 16209 13.DISCONNECT NO. 4 WATER BY-PASS PIPE SUB-ASSEMBLY

Hide 14.REMOVE EGR PIPE WITH COOLER SUB-ASSEMBLY (w/ DPF)

Hide 25601 15.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY (w/o DPF)

Hide 25804 16.REMOVE VACUUM CONTROL VALVE SET

Hide 17.REMOVE NO. 1 EGR COOLER AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A346657

Remove the 4 bolts and No. 1 EGR cooler and No. 2 EGR valve assembly with electric EGR control valve assembly from the intake manifold.


Hide 25681 18.REMOVE NO. 1 EGR COOLER

a.
A343910

Remove the 4 bolts and No. 1 EGR cooler from the No. 2 EGR valve assembly with electric EGR control valve assembly.


b.

Remove the gasket.