Home › Engine / Hybrid System › 2KD-FTV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM33J0E _51 Engine / Hybrid System _038447 2KD-FTV ENGINE MECHANICAL _0201072 REAR CRANKSHAFT OIL SEAL A

2KD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear engine oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
for 4WD:

Front wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)

PROCEDURE

Hide 31210 2.REMOVE CLUTCH COVER ASSEMBLY

Hide 31250 3.REMOVE CLUTCH DISC ASSEMBLY

Hide 13405 4.REMOVE FLYWHEEL SUB-ASSEMBLY

Hide 11381A 6.REMOVE REAR ENGINE OIL SEAL

a.
A352054C01
0.229,1.656 0.417,1.469 0.417,1.469 0.5,1.469 false 1.042,1.844 1.229,1.99 1.229,1.99 1.313,1.99 false 0.25,0.667 0.417,0.729 0.417,0.729 0.5,0.729 true 0.521,1.354 0.833,1.552 0.313,0.198 10 false *a 1.344,1.885 1.656,2.083 0.313,0.198 10 false *a 0.521,0.625 0.833,0.823 0.313,0.198 10 false *a
*a Cut Position


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a cloth and screwdriver, pry out the rear engine oil seal from the rear engine oil seal retainer.

NOTICE:

Be careful not to damage the crankshaft and rear engine oil seal retainer.


HINT:
·

After removal, check the crankshaft for damage. If damaged, smooth the surface with #400 sandpaper.

·

Tape the screwdriver tip before use.