The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the EGR cooler removal/installation are shown below.
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Replacement of diesel throttle body assembly | Perform initialization | - |
|
| Replacement of electric EGR control valve assembly | Perform initialization | - |
|
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
1.DRAIN ENGINE COOLANT
26100G
2.REMOVE DIESEL THROTTLE BODY ASSEMBLY
16278
3.REMOVE NO. 2 WATER BY-PASS PIPE
23265C
4.REMOVE GAS FILTER
89421C
5.REMOVE TURBO PRESSURE SENSOR
44763C
6.REMOVE NO. 2 HOSE TO HOSE TUBE
12632
7.REMOVE NO. 2 ENGINE COVER BRACKET
23300
8.DISCONNECT FUEL FILTER ASSEMBLY
82121
9.DISCONNECT ENGINE WIRE
25625
10.REMOVE EGR VALVE BRACKET
25612
11.REMOVE NO. 2 EGR PIPE
16206B
12.DISCONNECT NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disconnect the No. 4 fuel hose from the No. 3 water by-pass pipe sub-assembly.
Slide the clamp and disconnect the No. 8 water by-pass hose from the No. 3 water by-pass pipe sub-assembly.
Slide the clamp and disconnect the No. 9 water by-pass hose from the electric EGR control valve assembly.
Remove the 2 bolts and No. 3 water by-pass pipe sub-assembly from the No. 1 EGR cooler.
16209
13.DISCONNECT NO. 4 WATER BY-PASS PIPE SUB-ASSEMBLY
25601
14.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
25804
15.REMOVE VACUUM CONTROL VALVE SET
16.REMOVE NO. 1 EGR COOLER AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the 4 bolts and No. 1 EGR cooler and No. 2 EGR valve assembly with electric EGR control valve assembly from the intake manifold.
25681
17.REMOVE NO. 1 EGR COOLER
Remove the 4 bolts and No. 1 EGR cooler from the No. 2 EGR valve assembly with electric EGR control valve assembly.
Remove the gasket.