Home › Engine / Hybrid System › 2TR-FBE STARTING › STARTER › from 2016.07
RM33J0E _51 Engine / Hybrid System _053780 2TR-FBE STARTING _0262573 STARTER A

2TR-FBE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Connect the terminal cap.


d.

Connect the starter connector.


Hide 53882F 2.INSTALL FRONT FENDER SEAL LH

a.

Install the front fender seal LH with 6 new clips.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION