Home › General › INTRODUCTION › REPAIR INSTRUCTION › from 2016.07
RM33J0E _V1 General _038418 INTRODUCTION _0197447 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed Link
ECM
for 2TR-FE:

Vehicle Identification Number (VIN) registration


DTC P0630 is output (Click here)
for 2TR-FBE:

Vehicle Identification Number (VIN) registration


DTC P0630 is output (Click here)
for 1GD-FTV, 2GD-FTV:
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


for 1GD-FTV:(Click here)
for 1GD-FTV, i-ART:(Click here)
for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1KD-FTV, 2KD-FTV:
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


Engine starting for 1KD-FTV:(Click here)
for 2KD-FTV:(Click here)
for RC60, RC61:

Performing iMT installation information reset


·

iMT system

·

DTCs are output


(Click here)
for RC60F, RC61F:

Performing iMT installation information reset


·

iMT system

·

DTCs are output


(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.
Engine assembly
for 2TR-FE:

Inspection after repair


Poor idle, engine start, etc. (Click here)
for 2TR-FBE:

Inspection after repair


Poor idle, engine start, etc. (Click here)
for 1GD-FTV (except i-ART), 2GD-FTV:
·

Input Injector Compensation Code

·

Pilot Quantity Learning


Engine starting for 1GD-FTV:(Click here)
for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1GD-FTV, 2GD-FTV:

Clear Crank Time Compensation Data


Engine starting for 1GD-FTV:(Click here)
for 1GD-FTV, i-ART:(Click here)
for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1KD-FTV, 2KD-FTV:
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting for 1KD-FTV:(Click here)
for 2KD-FTV:(Click here)
for 1GD-FTV (except DPF), 2GD-FTV (except DPF):

Crankshaft position sensor plate


Clear Crank Time Compensation Data Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data for 1GD-FTV:(Click here)
for 1GD-FTV, i-ART:(Click here)
for 2GD-FTV:(Click here)
for 1GD-FTV (w/ DPF), 2GD-FTV (w/ DPF):

Crankshaft angle sensor plate


Clear Crank Time Compensation Data Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1GD-FTV (w/ DPF), 2GD-FTV (w/ DPF):

Air fuel ratio sensor


Clear A/F Sensor Compensation data - for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1GD-FTV (w/ DPF), 2GD-FTV (w/ DPF):

Exhaust manifold converter sub-assembly


Clear DPF Thermal Deterioration Data - for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1GD-FTV, 2GD-FTV:
·

Diesel throttle body assembly

·

Electric EGR control valve assembly

·

Turbocharger sub-assembly

·

Turbocharger variable nozzle motor


Perform initialization - for 1GD-FTV:(Click here)
for 1GD-FTV, i-ART:(Click here)
for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1KD-FTV, 2KD-FTV:

Fuel supply pump assembly


Supply Pump Initialization Engine startability for 1KD-FTV:(Click here)
for 2KD-FTV:(Click here)
Injector assembly
for 1GD-FTV (except i-ART), 2GD-FTV:
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting for 1GD-FTV:(Click here)
for 1GD-FTV, w/ DPF:(Click here)
for 2GD-FTV:(Click here)
for 2GD-FTV, w/ DPF:(Click here)
for 1KD-FTV, 2KD-FTV:
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting for 1KD-FTV:(Click here)
for 2KD-FTV:(Click here)
for 1KD-FTV:
·

Diesel throttle body assembly

·

Turbocharger sub-assembly

·

Turbocharger variable nozzle motor


Perform initialization - (Click here)
for 2KD-FTV:

Diesel throttle body assembly


Perform initialization - (Click here)
Timing belt Mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


(Click here)
for 2TR-FE:
·

Throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock control sensor


Inspection after repair Poor idle, engine start, etc. (Click here)
for 2TR-FBE:
·

Throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Intake mass air flow meter sub-assembly

·

Fuel injector assembly

·

Fuel suction with pump and gauge tube assembly (fuel pump)

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock control sensor


Inspection after repair Poor idle, engine start, etc. (Click here)
for A750F:
·

Automatic transmission assembly

·

Transmission valve body assembly

·

Any of the shift solenoid valves


Reset memory
·

Large shift shock

·

Engine overruns


(Click here)
for A750F:

Automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
for AC60E:
·

Automatic transmission assembly

·

Transmission valve body assembly

·

Any of the shift solenoid valves


Reset memory
·

Large shift shock

·

Engine overruns


(Click here)
for AC60E:

Automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
for AC60F:
·

Automatic transmission assembly

·

Transmission valve body assembly

·

Any of the shift solenoid valves


Reset memory
·

Large shift shock

·

Engine overruns


for 1GD-FTV:(Click here)
for 2TR-FBE:(Click here)
for AC60F:

Automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
Skid control ECU (Brake actuator assembly)
w/o VSC:

Perform registration of rear differential lock identification information


·

DTCs are output

·

ABS warning light illumination


(Click here)
w/ VSC:

Yaw rate and acceleration sensor zero point calibration and store system information


·

DTCs are output

·

ABS warning light illumination

·

Slip indicator light illumination

·

VSC disable or malfunctioning


(Click here)
·

Yaw rate and acceleration sensor (airbag sensor assembly)

·

Front wheel alignment adjustment


·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


·

Air conditioning amplifier assembly

·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 2 air conditioning radiator damper servo sub-assembly

·

No. 1 blower damper servo sub-assembly


Servo motor initialization DTCs are output (Click here)
w/ Smart Entry and Start System:
·

Certification ECU (smart key ECU assembly)

·

Steering lock ECU (steering lock actuator assembly)

·

Electrical key transmitter sub-assembly


Code registration
·

Wireless door lock control system

·

Smart entry and start system

·

Immobiliser system

·

Steering lock system


Refer to the Service Bulletin for the registration procedure.
w/o Smart Entry and Start System:
·

Key

·

Transponder key ECU assembly


Code registration Engine starting Refer to the Service Bulletin for the registration procedure.
w/o Smart Entry and Start System:
·

Door control transmitter assembly

·

Door control receiver


Recognition code registration Wireless door lock control system (Click here)
·

Power window regulator motor assembly

·

Door window regulator assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Jam protection function

·

Power window control system

·

Auto up and down function

·

Remote control function

·

Key-off operation function

·

Catch protection function


(Click here)
w/ Automatic Light Control System:

Body ECU


Initialize automatic light control system Automatic light control system (Click here)
w/ Automatic Headlight Beam Level Control System:
·

The headlight leveling ECU assembly is replaced with a new one.

·

The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation or replacement of the rear height control sensor sub-assembly LH.


Headlight leveling ECU assembly initialization Headlight leveling function (Click here)