Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER › from 2016.07
RM33J0E _54 Brake _038478 BRAKE SYSTEM (OTHER) _0189454 BRAKE BOOSTER A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 44785 1.INSTALL BRAKE BOOSTER GASKET

a.

Install a new brake booster gasket to the brake booster assembly.


Hide 44610 2.INSTALL BRAKE BOOSTER ASSEMBLY

a.

Install the brake booster assembly with the 4 nuts.

Torque:
18.4 N*m (188 kgf*cm, 14 ft.*lbf)


b.

for Diesel:

i.

Install the 2 new grommets to the brake booster assembly.


ii.

Install the vacuum warning switch assembly to the brake booster assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM WARNING SWITCH(for Diesel)>INSTALLATION


iii.

Install the 2 brake vacuum check valve assemblies to the brake booster assembly.



c.

for 2TR-FE, 2TR-FBE:

i.

Install the 2 new grommets to the brake booster assembly.


ii.

Install the 2 vacuum check valve assemblies to the brake booster assembly.



Hide 47201 3.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 4.CONNECT VACUUM HOSE

a.

except 2TR-FE, 2TR-FBE:

Connect the vacuum hose to the brake vacuum check valve assembly, and slide the clip to secure it.


b.

for 2TR-FE, 2TR-FBE:

Connect the 2 vacuum hoses to each brake vacuum check valve assembly, and slide the 2 clips to secure it.


Hide 47264D 5.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Install the brake master cylinder push rod clevis to the brake booster assembly.


Hide 47264A 6.INSTALL PUSH ROD PIN

Hide 47101A 7.INSTALL BRAKE PEDAL RETURN SPRING

Hide 8.BLEED BRAKE SYSTEM (w/ VSC)

Hide 9.BLEED BRAKE SYSTEM (w/o VSC)

Hide 10.BLEED CLUTCH LINE (for Manual Transmission)

Hide 11.CHECK AND ADJUST BRAKE PEDAL HEIGHT