Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR SEAT CUSHION ASSEMBLY
64271C
2.REMOVE BACK PANEL TRIM
73370C
3.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)
Remove the bolt and disconnect the floor anchor of the rear No. 1 seat outer belt assembly LH.
62514A
4.REMOVE LOWER QUARTER TRIM PANEL LH
73178C
5.REMOVE SEAT BELT ANCHOR COVER CAP
Use the same procedure for both seat belt anchor cover caps.
| *a | Protective Tape |
Put protective tape around the seat belt anchor cover cap.
| *a | Protective Tape |
|
Insert Thin-bladed Screwdriver Here |
|
Remove in this Direction |
Insert a thin-bladed screwdriver at the position shown in the illustration and detach the claw and remove the seat belt anchor cover cap.
Tape the thin-bladed screwdriver tip before use.
73370C
6.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt and disconnect the shoulder anchor of the rear No. 1 seat outer belt assembly LH.
Remove the bolt.
Detach the 2 guides and remove the rear No. 1 seat outer belt assembly LH.