Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY(for Smart Cab) › from 2016.10
RM33J0E _58 Vehicle Interior _040893 SEAT BELT _0292512 REAR SEAT OUTER BELT ASSEMBLY(for Smart Cab) A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY(for Smart Cab)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 73370C 1.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

B415718

a.

Attach the 2 guides and temporarily install the rear No. 1 seat outer belt assembly LH with the bolt.


b.

Tighten the bolt.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


c.
B415717

Connect the shoulder anchor of the rear No. 1 seat outer belt assembly LH with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 73178C 2.INSTALL SEAT BELT ANCHOR COVER CAP

HINT:

Use the same procedure for both seat belt anchor cover caps.


a.
B421120C01
0,0 0,0 false
V113147

Install in this Direction


Attach the claw to install the seat belt anchor cover cap as shown in the illustration.


Hide 62514A 3.INSTALL LOWER QUARTER TRIM PANEL LH

Hide 73370C 4.CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)

a.
B415716

Install the bolt and connect the floor anchor of the rear No. 1 seat outer belt assembly LH.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 6.INSTALL REAR SEAT CUSHION ASSEMBLY