Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB › 2015.08–2016.01
RM3270E _52 Drivetrain _041686 AXLE AND DIFFERENTIAL _0195329 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43502F 1.INSTALL FRONT AXLE HUB OIL SEAL LH

a.
F042762

Using a brass bar and hammer, tap in a new front axle hub oil seal LH.


Hide 43502M 2.INSTALL FRONT AXLE HUB INNER BEARING LH

a.
C325047N01
0.479,1.771 0.948,1.948 false 0.177,1.667 0.635,1.865 0.458,0.198 10 false SST

Using SST and a press, press a new front axle hub inner bearing LH into the front axle hub sub-assembly LH.

SST
09649-17010  

NOTICE:

Insert 4 bolts into the bearing before installing the bearing to the front axle hub sub-assembly LH.



Hide 43502C 3.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

C328308C01
2.875,1.271 3.188,1.469 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


a.

Apply MP grease to a new O-ring.


b.

Install the O-ring to the axle hub.


c.

Install the dust cover and front axle hub sub-assembly LH to the steering knuckle LH with the 4 bolts.

Torque:
Specified tightening torque : 80 N*m (816 kgf*cm, 59 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a ball joint lock nut wrench (fulcrum length of 149 mm (5.866 in.)) + torque wrench (fulcrum length of 380 mm (14.961 in.)): 57.5 N*m (586 kgf*cm, 42 ft.*lbf).




Hide 43502H 4.INSTALL FRONT AXLE SHAFT NUT LH

C324911

a.

Clean the threaded parts on the drive shaft and front axle shaft nut LH using a non-residue solvent.


b.

Install the front axle shaft nut LH.

Torque:
235 N*m (2396 kgf*cm, 173 ft.*lbf)


c.

Install the adjusting cap and a new cotter pin.

NOTICE:

If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.



Hide 43514C 5.INSTALL FRONT AXLE HUB GREASE CAP LH

a.

Install a new front axle hub grease cap LH to the front axle hub sub-assembly LH.


Hide 43512 6.INSTALL FRONT DISC

Hide 47750 7.CONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH

Hide 89543 8.CONNECT FRONT SPEED SENSOR LH

Hide 9.INSTALL FRONT WHEEL