Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE SHAFT › 2015.08–2016.01
RM3270E _52 Drivetrain _041686 AXLE AND DIFFERENTIAL _0195332 REAR AXLE SHAFT A

AXLE AND DIFFERENTIAL  REAR AXLE SHAFT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42312C 1.INSTALL REAR AXLE SHAFT OIL SEAL LH

a.
C328778C01
1.104,2.135 1.448,2.073 1.448,2.073 1.333,2.271 false 1.49,1.99 1.948,2.188 0.458,0.198 10 false SST 1.219,3.083 1.677,3.281 0.458,0.198 10 false *a
*a Depth


Using SST and a hammer, tap in a new rear axle shaft oil seal LH.

SST
09950-60020  (09951-00680)
09950-70010  (09951-07150)

Standard depth:

6.3 to 7.3 mm (0.249 to 0.287 in.)



b.

Coat the lip of the rear axle shaft oil seal LH with MP grease.


Hide 42422B 2.INSTALL REAR AXLE BEARING CASE O-RING LH

a.

Install a new rear axle bearing case O-ring LH to the rear axle housing.


Hide 3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE

a.
C328764

Install the rear axle shaft with backing plate with the 4 nuts.

Torque:
60 N*m (612 kgf*cm, 44 ft.*lbf)


Hide 89546 4.CONNECT REAR SPEED SENSOR LH

a.
C331234

Connect the rear speed sensor LH to the rear axle housing with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 46430 5.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Connect the No. 3 parking brake cable assembly with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 7.ADJUST PARKING BRAKE