This DTC is stored when a malfunction occurs in the speakers.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C3 | Speaker Output Short | A short is detected in the speaker output circuit. | ·
Speakers ·
Harness or connector ·
Navigation receiver assembly |
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
*1: for LH Side
*2: for RH Side
Disconnect the G43 and G44 navigation receiver assembly connectors.
Disconnect the K4*1 and/or J3*2 front No. 1 speaker assembly connector.
Disconnect the K7*1 and/or J6*2 front No. 2 speaker assembly connector.
Disconnect the M2*1 and/or L2*2 rear speaker assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G43-2 (FL+) - K7-4 (TWL+) | Always | Below 1 Ω |
| G43-6 (FL-) - K7-2 (TWL-) | Always | Below 1 Ω |
| K7-3 (+) - K4-1 | Always | Below 1 Ω |
| K7-1 (-) - K4-2 | Always | Below 1 Ω |
| G44-2 (RL+) - M2-1 | Always | Below 1 Ω |
| G44-6 (RL-) - M2-2 | Always | Below 1 Ω |
| G43-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| G43-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| G44-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| G44-6 (RL-) - Body ground | Always | 10 kΩ or higher |
| K7-3 (+) - Body ground | Always | 10 kΩ or higher |
| K7-1 (-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G43-1 (FR+) - J6-4 (TWR+) | Always | Below 1 Ω |
| G43-5 (FR-) - J6-2 (TWR-) | Always | Below 1 Ω |
| J6-3 (+) - J3-1 | Always | Below 1 Ω |
| J6-1 (-) - J3-2 | Always | Below 1 Ω |
| G44-1 (RR+) - L2-1 | Always | Below 1 Ω |
| G44-3 (RR-) - L2-2 | Always | Below 1 Ω |
| G43-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| G43-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| G44-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| G44-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| J6-3 (+) - Body ground | Always | 10 kΩ or higher |
| J6-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly connector.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly connector.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 2 speaker assembly with a known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Clear the DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR
Connect all the connectors to the front No. 2 speaker assemblies that were disconnected.
When there is a possibility that either the right or left front speaker is defective, inspect by interchanging the right one with the left one.
Perform the above inspection on both LH and RH sides.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG