Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER
RM3270E _56 Audio / Visual / Telematics _041699 AUDIO / VIDEO _0203169 FRONT DOOR SPEAKER A

AUDIO / VIDEO  FRONT DOOR SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door speaker removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power back door system (Click here)

CAUTION:
B403904

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67491A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH

Hide 86160P 4.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

a.
E310282

Detach the claws and front No. 2 speaker assembly.


Hide 5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Hide 74210 6.REMOVE FRONT ARMREST ASSEMBLY RH

Hide 69283 7.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH

Hide 67601 8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

Hide 86160 9.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

a.
E318960N01
2.802,2.052 2.958,2.25 0.156,0.198 10 false A

Disconnect the connector.


b.

Put a 5 mm (0.197 in.) drill bit into a drill.


c.

Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.

NOTICE:

Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going to deep.


Standard
Area Specified Condition
A 4 mm (0.157 in.)


d.

Lightly press the drill against the rivets, drill off the flanges of the 3 rivets and remove the front No. 1 speaker assembly.

CAUTION:

Be careful of the drilled rivet as it may become hot.


NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.




e.

Continue drilling and push out the remaining rivet fragments.


f.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.