The headlight leveling ECU assembly stores this DTC if the sensor value received from the height control sensor is out of range when performing initialization of the headlight leveling ECU assembly; for example, the vehicle is not level or being jacked up.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2452 | Height Control Sensor Data Out of Range When Initializing | Rear height control sensor sub-assembly LH value is out of range when initializing | ·
Vehicle condition when initializing ·
Headlight leveling ECU assembly |
If the headlight leveling ECU assembly has been replaced, it is necessary to initialize the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Check the rear height control sensor sub-assembly LH installation condition.
| Result | Proceed to |
|---|---|
| Rear height control sensor sub-assembly LH installation condition is normal | A |
| Rear height control sensor sub-assembly LH installation condition is abnormal | B |
A
B
Perform initialization of the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Before initializing the headlight leveling ECU assembly, make sure that the vehicle condition is proper for initialization.
Be sure to perform initialization as instructed.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, recheck for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
DTC B2452 is not output.
If the headlight leveling ECU assembly stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG