Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU › 2015.08–2016.01
RM3270E _59 Vehicle Exterior _041720 LIGHTING (EXT) _0199686 HEADLIGHT LEVELING ECU A

LIGHTING (EXT)  HEADLIGHT LEVELING ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight leveling ECU assembly installation/removal are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power back door system (Click here)
The headlight leveling ECU assembly is replaced with a new one Headlight leveling ECU assembly vehicle information registration Automatic headlight beam level control system (Click here)
Headlight leveling ECU assembly initialization

PROCEDURE

Hide 45287 1.REMOVE LOWER STEERING COLUMN COVER

Hide 2. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55667 4.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH

Hide 55011A 5.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55606 6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 73900 7.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 89960 8.REMOVE HEADLIGHT LEVELING ECU ASSEMBLY

a.
E319917

Disconnect the connector.


b.
E319918

Remove the nut and headlight leveling ECU assembly.