Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)
RM3270E _58 Vehicle Interior _041710 SUPPLEMENTAL RESTRAINT SYSTEMS _0199693 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 73910A 1.INSTALL FRONT SEAT AIRBAG ASSEMBLY RH

a.

Install the front seat airbag assembly RH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

NOTICE:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.




b.

Attach the wire harness clamp.

NOTICE:

Be careful not to damage the airbag wire harness.



Hide 2.INSTALL SEATBACK COVER WITH PAD

Hide 71931 3.INSTALL FRONT SEAT HEADREST SUPPORT

Hide 71759C 4.INSTALL FRONT NO. 1 SEATBACK HOOK

Hide 5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH

Hide 71861 6.INSTALL FRONT SEAT INNER CUSHION SHIELD RH

Hide 71811D 7.INSTALL FRONT SEAT CUSHION SHIELD RH

Hide 72494 8.INSTALL VERTICAL ADJUSTING HANDLE RH (for Driver Side)

Hide 72525A 9.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION